Hammer Drive® Pins On Anchors Unlimited, Inc.


	Hammer Drive® Pins
	Check up to five results to perform an action.

larger image Hammer Drive® pins are designed for permanently fastening a fixture to concrete and some types of masonry. This fastener is designed for use in a standard hand tool and should not be used in a powder actuated tool. The pins are formed with a 1/4" diameter head on one end and a 0.140" diameter shank in various lengths. A 3/8" diameter steel washer is mounted over the point to retain the drive pin in the fastener guide of the tool providing guidance during the driving operation. This fastener is recommended for light duty static load applications where holding power is not a critical factor. It should not be used overhead.

Results Per Page :

Item #	Item Name	Shank Length	Head Diameter	Shank Diameter

50294	1/4" Head Hammer Drive® Pin	3/4 in	1/4 in	0.140

50296	1/4" Head Hammer Drive® Pin	1 in	1/4 in	0.140

50298	1/4" Head Hammer Drive® Pin	1 1/4 in	1/4 in	0.140

50300	1/4" Head Hammer Drive® Pin	1 1/2 in	1/4 in	0.140

50302	1/4" Head Hammer Drive® Pin	2 in	1/4 in	0.140

50304	1/4" Head Hammer Drive® Pin	2 1/2 in	1/4 in	0.140

50306	1/4" Head Hammer Drive® Pin	3 in	1/4 in	0.140

50310	Standard - Hammer Drive® Setting Tool	N/A	N/A	N/A

Hammer Drive® Pins